From a scan: the Constructor
The Constructor is Fabricator’s 3D editor in the browser, at app.fabricator.hr. Use it when the job starts from a 3D scan or a point cloud: you load the scan, trace the wireframe over it, and save the wireframe as a Rhino file. The patterning itself (the Atlas, seam types, the 3D solve, the 2D patterns and the nest) is done in Rhino, with the Fabricator plugin.
Open it from the website: Constructor in the site’s header, or Open the Constructor on Home.
Signing in
Section titled “Signing in”The Constructor works without signing in: drawing, importing, saving and the browser’s own autosave all work signed out. The foot of its sidebar says which it is:
- “Signed in as” and your email: you are signed in on the website in this browser.
- “Not signed in · Sign in”: Sign in opens the website’s sign-in page in a new tab, so your drawing stays open.
- “Fabricator website unreachable”: the Constructor cannot reach the website right now. Keep working; nothing is lost.
Connection and plan, just above, holds the same details as a text you can copy into a message to support. Exit Constructor takes you back to the website’s Home.
What you can do in it
Section titled “What you can do in it”- Bring in what you measured. Import offers Load Point Cloud (XYZ/PLY), Import OBJ / STL (select folder), Import DXF and Import Leica. Point clouds and scans are shown as a backdrop to trace over.
- Open a Rhino file. Open Rhino file opens a .3dm as a new project, with its curves, their edge types and its units.
- Draw and edit the wireframe. The sidebar has the drawing tools (polyline, line, curve, point) and the editing tools (move, split, trim, join, offset, extend, extrude and more), as in Rhino with the plugin.
- Check and heal it. Check marks the frame: a red ! at each open end, orange where two curves pass close without touching, yellow where curves overlap. Esc clears the marks. Heal closes microscopic gaps in the selected curves and joins chains of Fixed edge and Join curves, in one undo step.
- Save the project. Save and Open keep the project as a file on your computer; New starts another. The browser also keeps an autosave.
Take the wireframe into Rhino
Section titled “Take the wireframe into Rhino”-
Click Save As, then Rhino file (.3dm), a copy.
-
Choose where to save it. The Constructor writes a Rhino file and leaves your project as it was.
-
Open the file in Rhino 8 and start Fabricator. The curves are on the Fabricator edge-type layers, in millimetres, and connected as they were in the Constructor, so the plugin takes them as its own wireframe.
-
Go on from the Atlas, as for a wireframe drawn in Rhino.
The other choices under Save As are Full project (drawing + scans), Drawing only (no scans), and Wireframe (.dxf), a copy for other software.
What is not in the Constructor yet
Section titled “What is not in the Constructor yet”The Constructor does not make patterns today. The Atlas, the seam types on the panels, the 3D solve, the 2D patterns and the nest are in the Rhino plugin only.
A few things on its screen belong to that later patterning and do nothing useful yet:
- Shop settings (in the bar at the bottom) keep seam types, materials and other shop settings in your account. The Rhino plugin does not read them: its seam types are in the plugin’s Settings → Seam Types, see the Seam profile guide.
- Solve! hands the solve to a Rhino plugin running on the same computer; without one it says “Could not connect to Rhino.” Solve in Rhino instead.
- The hint about opening the 2D map with F2 does not apply: there is no 2D map in the Constructor yet.
The plugin’s Send to Constructor button only works when the Constructor is already open on the same computer, which reads what the button sends.