Skip to content

Edge types

Every curve of a wireframe has an edge type: its role in the fabric. The edge type is the curve’s layer, under Fabricator in Rhino’s layers, and the layer’s colour shows it in the viewport. You set it with the Edge Types buttons in the 3D Frame section of the Fabricator panel; see Draw the wireframe.

The colours are the defaults. Change them in Settings → Wireframe Colors.

Colour Edge type What it is Use it for
black Fixed edge An edge that stays exactly where you drew it. Rails, frame tubes, tracks: where the fabric is held.
blue Cable An edge pulled tight between its ends, like a cable in a hem. The solver finds its curve. Free edges with a cable or a tensioned hem.
light blue Seam A seam between two panels: the fabric is cut here. The solver lets it settle into its own shape with the fabric; it is not held where you drew it. Where two panels are sewn together. Every edge of a cushion.
grey Join A line the fabric is held on, but not cut along. A fold line.
red Anchor A point, not a curve, that ties the fabric down. The tip of a pole under a full cover; a corner.
dark red Assist A helper line inside a piece. It shapes the fabric but does not split the piece. A support under the fabric, to improve the shape.
magenta Excluded A line drawn across a loop, from one point of its edge to another, that crosses it out: no panel is made there. Openings in the frame that carry no fabric.
purple Leaf A line drawn across a loop, in the same way, that makes it an extra piece on the edges it shares. A divider inside a cushion; a flap on one edge of a box.

Click an edge type with curves selected and they move to its layer. Click it with nothing selected and Rhino starts a polyline on it (for Anchor, it starts placing points). Either way, that layer becomes the current layer.

Most covers need only three edge types. Where the fabric is held on the frame, the edge is a Fixed edge. A free edge with a cable in its hem is a Cable: the solver pulls it tight and finds the curve it takes. Where two panels are sewn together, the edge is a Seam.

A cover held on three sides, with a cable along the free front edge and one seam.

Panels appear wherever edges close a loop. When a loop is an opening, such as the open front of a cover, cross it out: draw a line on Excluded from one corner of the loop to the opposite one. Both ends must be on the loop’s edge; a line that touches the loop at one end only does nothing.

A cover that is open at the front: the front loop is crossed out.

Normally an edge is shared by two panels at most. A divider inside a cushion is a third piece on the seams of the top and the bottom. Draw the divider like any other panel, then cross it out with a line on Leaf, corner to corner, as for Excluded. The divider becomes a third piece on the seams it shares with the top and the bottom.

A cushion with a wall across the middle. The Leaf line marks the wall as the extra piece.

Under Details in the 3D Frame section are three more layers, under Fabricator::Details. They are not edges of the fabric but marks on it. With curves selected, a click moves them to the layer; with nothing selected, it starts drawing on the solved 3D mesh, or an ordinary polyline when there is no solved mesh.

Colour Layer What it is
green Detail A detail line on the fabric: a reference line or mark for the sewer.
orange Cutout A cutout outline. A closed shape inside a panel becomes a hole.
cyan Reinf A reinforcement outline: a patch sewn on the panel.

The same three kinds can also be drawn on the flat panels in the Atlas; see Details.